File Size: 4.87 mb
Description
CNC machining is a manufacturing process in which pre-programmed computer software dictates the movement of factory tools and machinery. The process can be used to control a range of complex machinery, from grinders and lathes to mills and routers. With CNC machining, three-dimensional cutting tasks can be accomplished in a single set of prompts. Short for “computer numerical control,” the CNC process runs in contrast to — and thereby supersedes — the limitations of manual control, where live operators are needed to prompt and guide the commands of machining tools via levers, buttons and wheels. To the onlooker, a CNC system might resemble a regular set of computer components, but the software programs and consoles employed in CNC machining distinguish it from all other forms of computation
The Following is a list of the larger changes made to this manual since its last printing. Other less Significant changes were also made throughout.
- Capability of using two 1394 drives
- Addition of 1394-related error messages
Content:-
Chapter 1: Using this manual
Chapter 2: Basic control operation
Chapter 3: Offset Tables and setup
Chapter 4: Manual/MDI operation modes
Chapter 5: Editing programs Online
Chapter 6: Editing programs offline
Chapter 7: Running a program
Chapter 8: Data Display
Chapter 9: Introduction to programming
Chapter 10: Basic Control Operation
Chapter 11: Overtravels and programmable zones
Chapter 12: Coordinate control
Chapter 13: Axis Motion
Chapter 14: Using Quickpath plust
Chapter 15: Chamfering and Corner Radius
Chapter 16: Spindles
Chapter 17: Programming Feedrates
Chapter 18: Dual Axis Opration
Chapter 19: tool Control Functions
Chapter 20: Tool Tip Radius Compensation (TTRC)Function
Chapter 21: Single-Pass Turning Cycles
Chapter 22: Grooving/cutoff Cycles
Chapter 23: Compound turning Routines
Chapter 24: Thread Cutting
Chapter 25: Drilling Cycles
Chapter 26: Skip and Gauge probing Cycles
Chapter 27: Paramacros
Appendix A: Softkey Tree
Appendix B: Error and system Messages
Appendix C: G-code Tables
Author Details
"Allen-Bradley "
You May Also Like:-
No comments:
Post a Comment