File Size: 4.37 mb
Description
CNC machining is a manufacturing process in which pre-programmed computer software dictates the movement of factory tools and machinery. The process can be used to control a range of complex machinery, from grinders and lathes to mills and routers. With CNC machining, three-dimensional cutting tasks can be accomplished in a single set of prompts.Short for “computer numerical control,” the CNC process runs in contrast to — and thereby supersedes — the limitations of manual control, where live operators are needed to prompt and guide the commands of machining tools via levers, buttons and wheels. To the onlooker, a CNC system might resemble a regular set of computer components, but the software programs and consoles employed in CNC machining distinguish it from all other forms of computation.
When a CNC system is activated, the desired cuts are programmed into the software and dictated to corresponding tools and machinery, which carry out the dimensional tasks as specified, much like a robot.
The following is a list of the larger changes made to this manual since its last printing. Other less significant changes were also made throughout.
- Error Message Log
- Paramacro Parameters
- Softkey Tree
- Error Messages
Content:-
Chapter 1: Using This Manual
Chapter 2: Basic Control Operation
Chapter 3: Offset Tables and Setup
Chapter 4: Manual/MDI Operation Modes
Chapter 5: Editing Programs Online
Chapter 6: Editing Part Programs Offline (ODS)
Chapter 7: Running a Program
Chapter 8: Display and Graphics
Chapter 9: Communications
Chapter 10: Introduction to Programming
Chapter 11: Coordinate Systems Offsets
Chapter 12: Overtravels and Programmable Zones
Chapter 13: Coordinate Control
Chapter 14: Axis Motion
Chapter 15: Using QuickPath Plust
Chapter 16: Using Chamfers and Corner Radius
Chapter 17: Spindles
Chapter 18: Programming Feedrates
Chapter 19: Dual---axis Operation
Chapter 20: Tool Control Functions
Chapter 21: Cutter Diameter Compensation (G40, G41, G42)
Chapter 22: Using Pocket Milling Cycles
Chapter 23: Using Post Milling Cycles
Chapter 24: Using Hemisphere Milling Cycles
Chapter 25: Irregular Pocket Milling Cycles
Chapter 26: Milling Fixed Cycles
Chapter 27: Skip, Gauge, and Probing Cycles
Chapter 28: Paramacros
Chapter 29: Program Interrupt
Chapter 30: Using a 9/Series Dual-processing System
Chapter 31: Using Transfer Line Cycles
Appendix A: Softkey Tree
Appendix B: Error and System Messages
Appendix C: G-code Tables
Author Details
"Allen-Bradley"
You May Also Like:-
No comments:
Post a Comment